Wall Mounted Sensor Plate and Spout
# ET2-20.5DC (battery only)
# ET2-20.5AC/DC (mains power with battery back-up)
The sensor is wall-mounted and is activated by standing in front of the sensor plate. A 1-2 second time delay and specially set activation zones will eliminate false activations by passing traffic. Placement of sensor; allows for this tap to be considered in all areas where stainless steel basins or troughs are installed, although consideration may still need to be given to how light and reflective surfaces could affect the sensor. Minimum surfaces make this sensor tap ideal for Hospitals, Medical Clinics, Laboratories, Supermarkets and any area where hygiene is a priority.
There is no set runtime for any of the Enviro-Tech sensor tap range. This sensor tap model is activated when a 'body' is detected in the sensor field - 'water on', on exit - 'water off'. This offers maximum water savings.
Features
- Low energy consumption and long life batteries allow for up to 110,000 cycles battery life
- Hygienic ‘no-touch’ operation
- Automatic shut off after one minute if sensor is obstructed
- Wall Mounted Sensor Plate
- Slim design with minimal surfaces
- 6 Star WELS rating
- AS/NZS 3718
- WaterMark
Technical Parameters
- Water Pressure 100kPa - 500kPa
- Single feed water supply
- Easy access to all parts through sensor plate for maintenance
- Water temperature 1-50ºC
- Power supply DC6V (4xAA Batteries), or mains with battery supply back up.
- Power consumption static ≤ 0.5W (DC), ≤ 3W (AC); standby 0.003W
- Water inlet G ½”
- Detection range 300-600mm
- Respond time 1-2 Seconds
- Single feed water supply
- IP54