Loading...
Australias largest range of sensor operated taps and urinal flush valves
ET2-OL20 Wall Mounted Sensor Tap

ET2-OL20 Wall Mounted Sensor Tap


[Contact us for a price]

Elite Range Wall Mounted Sensor Tap ET2-OL20

6 Star WELS - 4.5l per minute

# ET2-OL20DC (battery only)
# ET2-OL20AC/DC (mains power/battery back-up)

A wall-mounted, practical and modern sensor tap option suitable for use with bench mounted basins or over washplanes in pubs, restaurants, offices and hotels. Also highly suitable for use in residential bathrooms. For the ultimate in design, pair it with a matching sensor operated soap dispenser (ET2- 20SD). Please note that this sensor tap model is is not recommended for use with stainless steel troughs or basins. Consider the ET2-20.4 instead.

There is no set runtime for any of the Enviro-Tech sensor tap range, it is simply; hands in sensor field 'water on', remove hands 'water off'. This offers maximum water savings without compromising on design.

Features

  • Hidden sensor window for easy use and streamlined appearance
  • Low energy consumption and long life batteries allow for up to 110,000 cycles
  • Up to 70% water savings
  • Hygienic ‘no-touch’ on/off operation
  • automatically shuts off after one minute if the sensor is obstructed
  • 6 Star WELS water rating
  • AS/NZS 3718:2005

Enviro-Tech watermark

Technical Parameters

  • Water Temperature 1-50ºC
  • Confirmation time of 1-2 seconds
  • Must be rear fixed - ensure good access
  • Minimum height from the bottom of basin 250mm
  • DC6V 4 x AA battery operated or mains power adaptor with battery back-up
  • Power consumption static ≤0.5W(DC), ≤3W(AC)
  • Water inlet 15mm G ½ “
  • IP54

SPECIFICATION SUMMARY

Specification Summary ET2-OL20 Wall Mounted Sensor Tap

TECHNICAL DRAWINGS

Technical Drawing - ET2-OL20 Wall Mounted Sensor Tap Technical Drawing - ET2-OL20 Wall Mounted Sensor Tap Technical Drawing - ET2-OL20 Wall Mounted Sensor Tap Technical Drawing - ET2-OL20 Wall Mounted Sensor Tap Technical Drawing - ET2-OL20 Wall Mounted Sensor Tap

INSTALLATION INSTRUCTIONS

Stainless steel fixing plates available, see Accessories page. To view alternative options for installation see here

ET2-OL20 Wall Mounted Sensor Tap Installation Manual

Please Note:

With all infrared sensors, strong light and reflective surfaces can interfere with operation. The ET2-OL20 sensor tap is particularly susceptible to interference as the sensor faces down into the bottom of the basin. It is therefore not recommended for use with stainless steel troughs or basins.

If there is strong lighting above the basin, this can react with other reflective surfaces, e.g. the basin and/or sink waste causing intermittent self-activation. It may be necessary to adjust the sensor activation zone, please refer to the 'Technical' page for detailed instructions. In the event of any issues, please contact Enviro-Tech for advice.